Document Outline

• FOX Matrix 320x, FOX Matrix 14400
• Safety Instructions
• FCC Class A Notice
• Contents
• Introduction
  • About this Guide
  • About the FOX Matrix Switchers
    • Fiber Cable Transmission Modes
  • Definitions
  • Features
• Installation
  • Setup and Installation Checklist
    • Get Ready
    • Configure the Matrix Switcher
    • Perform Physical Installation
    • Install Software
  • Rear Panel Boards, Cabling, and Features
    • I/O Boards
    • Remote Port
    • Ethernet Connection
    • Reset Button and LED
    • Power Supply Modules and Indicator LEDs
    • Cooling Fan assemblies
  • Front Panel Features
  • Reset Operations
    • Performing Soft System Resets (Resets 3, 4, and 5)
• Programming Guide
  • Host Control Ports
    • Serial Ports
    • USB Port (FOX Matrix 320x)
    • Ethernet (LAN) Port
  • Host-to-Switcher Instructions
  • Switcher-initiated Messages
  • Switcher Error Responses
  • Using the Command and Response Tables
    • Command and Response Table for SIS Commands
    • Command and Response Table for IP- and SNMP-Specific SIS Commands
  • Special Characters
• Matrix Software
  • About this Program
    • Software Operation via Ethernet
    • Software Operation via a Serial Port
    • Software Operation via USB Port (FOX Matrix 320x)
  • Installing the Software
  • Using the Matrix Switchers Control Program
    • Activating a USB Port for the First Time
    • Starting the Program
    • IP Settings/Options Window
    • Updating Firmware
    • Uploading HTML Files
    • Windows Buttons, Drop Boxes, and Trash Can
    • Windows menus
    • Using Emulation Mode
    • Using the Help System
• HTML Operation
  • Opening the Embedded Web Pages
  • Status Tab
    • System Status Page
    • Input Link Page
  • Configuration Tab
    • System Settings Page
    • Passwords Page
    • Email Settings Page
    • SNMP Settings Page
    • Firmware Upgrade Page
  • File Management Tab
    • File Management Page
  • Control Tab
    • Set and View Ties Page
• Maintenance and Modifications
  • Mounting the Switcher
    • UL Guidelines
    • Mounting Instructions
  • Battery and Power Precautions
  • Removing and Installing an I/O Board or Blank Panel
    • Removing an I/O Board or Blank Panel
    • Installing an I/O Board or Blank Panel
  • Removing and Installing a Power Supply Module
    • Removing a Power Supply Module
    • Installing a Power Supply Module
  • Removing and Installing a Fan Module
    • Removing a Fan Module
    • Installing a Fan Module
• Ethernet Connection
  • Ethernet Link
    • Ethernet Connection
    • Default IP Address
    • Pinging to Determine the Extron IP Address
    • Pinging to Determine the Web IP Address
    • Configuring the Switcher for Network Use via the ARP Command
    • Connecting as a Telnet Client
    • Telnet Tips
  • Subnetting — A Primer
    • Gateways
    • Local and Remote Devices
    • IP Addresses and Octets
    • Subnet Masks and Octets
    • Determining Whether Devices Are on the Same Subnet
• Warranty & Contact Info