Document Outline

• Table of Contents
• Introduction
• Installing the Switch
  • Description of Hardware
  • Mounting the Switch
    • Stacking Switches on a Flat Surface
      • 1. Stick the self-adhesive rubber foot pads (that come with this package) on each of the 4 concav...
      • 2. Place the first switch on a firm flat surface where you want to install the stack.
      • 3. Repeat step 1 for each switch before stacking them. The rubber foot pads cushion the switch ag...
  • Installing a Module
    • 1. Disconnect power to the switch (modules are not hot-swappable).
    • 2. Remove the face plate on the appropriate slot by removing the two screws with a flat-head scre...
    • 3. Before opening the package that contains the module, touch the bag to the switch casing to dis...
    • 4. Remove the module from the anti-static shielded bag.
    • 5. Holding the module level, gently push it all the way into the slot along the guide rails, ensu...
    • 6. If you are sure the module is properly mated with the connector, tighten the retainer screws t...
  • VLAN Setting:
  • Connecting the Switch System
    • 1. Prepare the network devices you wish to network. Make sure you have installed 10BASE-T or 100B...
    • 2. Prepare straight-through shielded or unshielded twisted-pair cables with RJ-45 plugs at both e...
    • 3. Connect one end of the cable to the RJ-45 port of the network interface card, and the other en...
      • Notes: 1. When connecting to another compatible switch or hub, run straight-through cable between...
      • 2. Make sure each twisted-pair cable does not exceed 100 meters (328 feet).
      • 3. We advise using Category 5 cable for all network connections to avoid any confusion or inconve...
    • Connecting to a fiber optic Port
  • Powering On the Switch
    • 1. Plug the power cord into the power socket on the rear of the switch, and the other end into a ...
    • 2. Check the LED marked Power on the front panel to see if it is on. The unit will automatically ...
    • 3. The switch performs a self-diagnostic test upon power-on. (Note that this test takes several m...
  • Verifying Port Status
  • Verifying System Operation
• Product Specifications
  • Base Unit
    • Physical Characteristics
    • Switching Criteria
    • Traffic Control
  • Media Expansion Modules
    • Fiber Uplink Module
• Troubleshooting
  • Diagnosing Switch Indicators
  • Power and Cooling Problems
  • Installation
• Port and Cable Assignments
  • RJ-45 Port Description
  • Module ordering information:
• EMI Certification
  • FCC Class B Certification (USA)
    • 1. This device may not cause harmful interference, and
    • 2. This device must accept any interference received, including interference that may cause undes...
  • CE Mark Declaration of Conformance