SMC Networks SMC-EZ108FDT User Manual

SMC Networks Computer Accessories

Advertising
background image

EZ
Swi

Advertising
Table of contents

Document Outline

  • Table of Contents
  • Introduction
  • Installing the Switch
    • Description of Hardware
    • Mounting the Switch
      • Stacking Switches on a Flat Surface
        • 1. Stick the self-adhesive rubber foot pads (that come with this package) on each of the 4 concav...
        • 2. Place the first switch on a firm flat surface where you want to install the stack.
        • 3. Repeat step 1 for each switch before stacking them. The rubber foot pads cushion the switch ag...
    • Installing a Module
      • 1. Disconnect power to the switch (modules are not hot-swappable).
      • 2. Remove the face plate on the appropriate slot by removing the two screws with a flat-head scre...
      • 3. Before opening the package that contains the module, touch the bag to the switch casing to dis...
      • 4. Remove the module from the anti-static shielded bag.
      • 5. Holding the module level, gently push it all the way into the slot along the guide rails, ensu...
      • 6. If you are sure the module is properly mated with the connector, tighten the retainer screws t...
    • VLAN Setting:
    • Connecting the Switch System
      • 1. Prepare the network devices you wish to network. Make sure you have installed 10BASE-T or 100B...
      • 2. Prepare straight-through shielded or unshielded twisted-pair cables with RJ-45 plugs at both e...
      • 3. Connect one end of the cable to the RJ-45 port of the network interface card, and the other en...
        • Notes: 1. When connecting to another compatible switch or hub, run straight-through cable between...
        • 2. Make sure each twisted-pair cable does not exceed 100 meters (328 feet).
        • 3. We advise using Category 5 cable for all network connections to avoid any confusion or inconve...
      • Connecting to a fiber optic Port
    • Powering On the Switch
      • 1. Plug the power cord into the power socket on the rear of the switch, and the other end into a ...
      • 2. Check the LED marked Power on the front panel to see if it is on. The unit will automatically ...
      • 3. The switch performs a self-diagnostic test upon power-on. (Note that this test takes several m...
    • Verifying Port Status
    • Verifying System Operation
  • Product Specifications
    • Base Unit
      • Physical Characteristics
      • Switching Criteria
      • Traffic Control
    • Media Expansion Modules
      • Fiber Uplink Module
  • Troubleshooting
    • Diagnosing Switch Indicators
    • Power and Cooling Problems
    • Installation
  • Port and Cable Assignments
    • RJ-45 Port Description
    • Module ordering information:
  • EMI Certification
    • FCC Class B Certification (USA)
      • 1. This device may not cause harmful interference, and
      • 2. This device must accept any interference received, including interference that may cause undes...
    • CE Mark Declaration of Conformance
Popular Brands
Popular manuals