Document Outline

• Contents
• About This Manual
  • Introduction
  • Chapter Descriptions
  • Notational Conventions
  • Related Publications
  • Service Information
    • Symbol Support Center
• Chapter 1 The P470/P370 RF Scanner
  • Introduction
  • Rechargeable Battery
  • The Cradle
  • Quick Startup Instructions
  • Commonly Used P470/P370 Programming Bar Code
• Chapter 2 Set Up
  • Introduction
  • Unpacking
  • Setting Up the Cradle
    • Connecting to a Host
    • Wall Mounting
    • Pairing the Scanner with the Cradle
  • Optimizing RF Performance
    • Mounting
    • Coexistence in Spectrum24 Environments
    • Phaser-to-Phaser Co-Existence
  • Charging the Battery
    • Using the Cradle
    • Using the UBC 2000
  • Battery Charge
  • Charge Status LED Indications
  • Changing the Battery
    • Removing the Battery
    • Replacing the Battery
• Chapter 3 Operation
  • Introduction
  • Default Application
    • Initial Powerup
    • Scan and Transmit Application
    • Eliminating Repetitive Scanning
  • Communication Errors
    • RF Communication Errors
    • Host / Cradle Communication Errors
  • System Menu
  • 123Scan
    • Suffix Values
  • Scanning
    • Scan the Entire Symbol
    • Hold at an Angle
  • Decode Zone
  • Keypad Operation
• Chapter 4 Maintenance And Specifications
  • Introduction
  • Maintenance
  • Troubleshooting
  • Technical Specifications
  • Cradle Pin-outs
  • Beeper Indications / Default Application Error Codes
• Chapter 5 Parameter Menus
  • Introduction
  • Operational Parameters
  • Set Default Parameter
  • Communication Protocol
    • Scan & Transmit Application
  • Host Type
    • RS-232C Host Types
  • Host Response Timeout
  • RF Channel
  • RF Retries
  • Sleep Time
  • Decimal Separator
  • Key Click
  • Beeper Tone
  • Beeper Volume
  • Power Detect Beep
  • Beep After Good Decode
  • Laser On Time
  • Transmit “No Read” Message
  • Linear Code Type Security Level
    • Linear Security Level 1
    • Linear Security Level 2
    • Linear Security Level 3
    • Linear Security Level 4
  • Bi-directional Redundancy
  • Autodiscriminate Response Time
  • Enable/Disable UPC-E/ UPC-A/UPC-E1
  • Enable/Disable EAN-8/EAN-13
  • Enable/Disable Bookland EAN
  • Decode UPC/EAN Supplementals
  • Decode UPC/EAN Supplemental Redundancy
  • Transmit UPC-A/UPC-E/UPC-E1 Check Digit
  • UPC-A Preamble
  • UPC-E Preamble
  • UPC-E1 Preamble
  • Convert UPC-E to UPC-A
  • Convert UPC-E1 to UPC-A
  • EAN-8 Zero Extend
  • Convert EAN-8 to EAN-13 Type
  • UPC/EAN Security Level
    • UPC/EAN Security Level 0
    • UPC/EAN Security Level 1
    • UPC/EAN Security Level 2
    • UPC/EAN Security Level 3
  • UPC/EAN Coupon Code
  • Enable/Disable Code 128
  • Enable/Disable UCC/EAN-128
  • Lengths for Code 128
  • Enable/Disable ISBT 128
  • Enable/Disable Code 39
  • Enable/Disable Trioptic Code 39
  • Set Lengths for Code 39
  • Code 39 Check Digit Verification
  • Transmit Code 39 Check Digit
  • Enable/Disable Code 39 Full ASCII
  • Convert Code 39 to Code 32
  • Code 32 Prefix
  • Enable/Disable Code 93
  • Set Lengths for Code 93
  • Enable/Disable Interleaved 2 of 5
  • Set Lengths for Interleaved 2 of 5
  • I 2 of 5 Check Digit Verification
  • Transmit I 2 of 5 Check Digit
  • Convert I 2 of 5 to EAN-13
  • Enable/Disable Discrete 2 of 5
  • Set Lengths for Discrete 2 of 5
  • Enable/Disable Codabar
  • Set Lengths for Codabar
  • CLSI Editing
  • NOTIS Editing
  • Enable/Disable MSI Plessey
  • Set Lengths for MSI Plessey
  • MSI Plessey Check Digits
  • Transmit MSI Plessey Check Digit
  • MSI Plessey Check Digit Algorithm
  • Transmit Code ID Character
    • Symbol Code ID Characters
  • Pause Duration
  • RS-232C Parameters
    • Baud Rate
    • Parity
    • Check Receive Errors
    • Hardware Handshaking
    • Software Handshaking
    • Host Serial Response Time-out
    • RTS Line State
    • Stop Bit Select
    • ASCII Format
    • Intercharacter Delay
  • MCL-Net Parameters
    • MCL-Net Baud Rate
    • MCL-Net Hex Addressing Mode
    • Scanner Address
    • MCL-Net Transmit Retries
    • MCL-Net Frame Timeout
    • Scanner Decode Beep Type
  • Long Range Scanning Bar Codes
    • Aim Mode
    • Aim Duration
  • Numeric Bar Codes
    • Cancel
• Appendix A Bar Code Information
  • UCC/EAN-128
  • AIM Code Identifiers
• Appendix B Automatic Project Download
• Appendix C Radio Channels
  • Cordless Phaser RF Channels Per Country
• Appendix D Messages and Error Codes
  • Introduction
  • Messages
  • Communication Errors
    • Scanning Transmission Range
• Index
  • Numerics
  • A
  • B
  • C
  • D
  • E
  • F
  • H
  • I
  • K
  • L
  • M
  • N
  • O
  • P
  • Q
  • R
  • S
  • T
  • U
  • V
  • W
  • Y