Hoshizaki C-100BAF - Manual (Page 35)

35
12) Open the water supply line shut-off valve.
13) Plug the unit back in. Move the power switch to the "ON" position and allow the
icemaker to run. Check for leaks.
14) After 30 minutes, move the power switch to the "OFF" position. Unplug the unit.
15) Pour warm water into the storage bin to melt all of the ice, then clean the storage bin
liner, door liner, and door gasket with a neutral cleaner. Rinse thoroughly after cleaning.
16) Plug the unit back in. Move the power switch to the "ON" position to start the automatic
icemaking process.
C. Storage Bin Drain
In some conditions, slime may build up inside the storage bin drain and prevent water
from draining properly. To prevent this buildup, perform the following procedure once
every 3 months or as often as necessary for conditions.
NOTICE
If the storage bin drain becomes clogged, water could build up in the bin and
overflow, leading to costly water damage.
1) Move the power switch to the "OFF" position. WARNING! To reduce the risk of
electric shock, do not touch the power switch with damp hands.
2) Remove all ice from the storage bin.
3) Mix a batch of sanitizing solution by diluting 1.25 fl. oz. (37 ml or 2.5 tbs) of a
5.25% sodium hypochlorite solution (chlorine bleach) with 2.5 gallons (9.5 l) of warm
water. Using a chlorine test strip or other method, confirm that you have a concentration
of about 200 ppm.
4) Slowly pour the sanitizing solution into the storage bin.
5) After all of the solution has drained, clean the storage bin liner with a neutral cleaner.
Rinse thoroughly with clean water.
6) Move the power switch to the "ON" position to start the automatic icemaking process.