HP 3C509B-TP - Manual (Page 7)

1 Connecting to a Netware 3.12 Server
Windows 95 SR2
Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2 installed.
• 3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.0.
• Vectra VL8 Driver Name: W95EL5X9.INF Size: 16KB Date: 6/11/97
• Vectra VL7 Driver Name: Elnk.VXD Size: 30KB Date: 7/18/96
• Vectra VE7/VE8 Driver Name: W95EL5X9.INF Size: 16KB Date: 6/11/97
• Windows 95 SR2 media.
• Novell Netrware 3.12 server that supports Net BEUI, NWLink IPX/SPX,
and NWLink NetBIOS transfer protocols.
Device Configuration
• Boot PROM Disabled
• Transceiver Type Auto Select
• Network Driver Optimization Windows or OS/2 Client
• Maximum Modem Speed 9600 Bps
• Plug and Play Compatibility Disabled
• Full Duplex Disabled
Procedure
1 With the HP Vectra turned off install the 3COM Etherlink III 3C509-B
adapter card into an ISA slot.
2 Power on the machine and restart Windows 95 SR2 in MS-DOS Mode.
3 Insert the 3COM drivers diskette (ver. 5.0 downloaded from 3COM’s
website) and execute 3C5X9CFG.EXE.
4 Select “CONFIGURE NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
Vectra VL8 Vectra VL7 Vectra VE7/VE8
I/O Base Address 210 210 300
Interrupt Request
Level
10 10 10