Hitachi CP-X268A - Manual (Page 116)

6
6. Troubleshooting
6 . Troubleshooting
Problem Likely Cause Things to Check
Reference
Page
Number
No image
The projector is not turned
on.
Is the projector’s lamp on? *6
The projector’s input source
isn’t switched to MIU.
Is the projector switched to
MIU?
*7
Wireless / Wired
Live Mode
The projector
that you want
to connect to
is nowhere
to be found
on the list
of available
projectors
The PC and/or projector’s
network settings are not
configured correctly.
Check both the PC and
projector’s network settings.
If you change the projector’
s settings, turn off the
projector’s AC power and
then turn it on again. If you
simply put the projector in
STANDBY power mode and
then turn it on again, the
new settings might not take
effect.
0
Weak radio signal
• Bring the PC and projector
closer together
• Radio waves won’t go
through concrete and
metal (steel doors, etc.)
–
Can't
communicate
The Projector isn’t in Live
Mode
Check the mode on MIU
Menu to make sure that it is
in the correct mode.
53
The projected
image is
rather slow
compared to
that of the PC
The projector isn’t capable
of relaying dynamic images
such as PowerPoint®
animation at full speed.
Try increasing the Capture
Performance priority level.
It may improve the speed a
little.
58
“Optimize Performance” is
set to “Image quality”.
Try setting “Optimize
Performance” to
“Transmission speed”.
58
(continued on next page) * User’s Manual (detailed) - Operating Guide