Husqvarna 966004701 - Manual (Page 7)

8
1. Remove the discharge chute from the deck. (Deck
configuration will vary by size and model)
2. Lower deck to the lowest cutting position.
3. Remove the right hand (discharge side) belt cover
from the deck.
4. Relieve the tension from the deck belt and remove
from the center deck pulley.
(See Operator’s Manual if necessary)
ASSEMBLY
1
INSTALLING DRIVE PULLEY
5. Remove the nut securing the right hand deck
pulley to the spindle.
6. Install drive pulley included in collection system kit
on top of the current deck pulley.
7. Reinstall the nut on the spindle and torque to 55-
75 ft/lbs.
8. Reinstall the deck belt.
Deck Height
Adjustment
Belt Cover
Discharge Chute
Drive Pulley
1. Place blower assembly on secure table or stable
surface.
2. Remove the bolts securing the rear mount
bracket.
3. Using the hacksaw, trim the blower housing along
the recessed grooves.
4. Reinstall the rear mount bracket with previously
removed bolts.
2
TRIMMING BLOWER
Mount Bracket Rear
Tension Release Lever
Trim Line