Horizon Fitness CT9.1 - Manual (Page 10)

10
BOLT (A)
20 mm
Qty: 6 SPRING WASHER (B)
8.2 mm
Qty: 6 ARC WASHER (C)
8.2 mm
Qty: 6
HARdWARE bAG 1 CONTENTS :
BOLTS (A)
MAIN
FRAME
BOOT
CONSOLE MAST
SPRING
WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
CONSOLE CABLE
LEAD WIRE
ASSEMBLY STEp 1
A Cut the yellow banding straps and lift the
running deck upward to remove all contents
from underneath the running deck.
B Open HARdWARE bAG 1.
C Slide MAIN fRAME bOOT up CONSOlE
MAST. Place RIGHT CONSOlE MAST over
MAIN fRAME bRACkET.
D Pull lEAd WIRE through RIGHT CONSOlE
MAST. After pulling the lEAd WIRE through
the mast, the top of the CONSOlE CAblE
should be located at the top of the mast. Detach
and discard lEAd WIRE.
NOTE: Do not pinch CONSOlE CAblE when
placing the mast onto the MAIN fRAME
bRACkET.
E Attach CONSOlE MAST to MAIN fRAME
bRACkET using 3 bOlTS (A), 3 SpRING
WASHERS (b) and 3 ARC WASHERS (C).
F Slide MAIN fRAME bOOT down over MAIN
fRAME bRACkET.
g Repeat steps D–F on other side.