Huffy P/N 21147703 - Manual (Page 10)

10
P/N 21147703 03/04
Align dimple of middle pole with slot of bottom pole. While maintaining alignment, bounce
top and middle pole assembly (1 & 2) onto lower pole section (3) as shown until they no
longer move toward pole identification mark. 3.
WOOD SCRAP
(NOT SUPPLIED)
POLE
IDENTIFICATION
MARK
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH
THE HARDWARE
2
3
1
Bottom Pole
IDENTIFICATION
STICKER
Bottom Pole
IDENTIFICATION
STICKER
5"
1-1/2"
Holes in top (1) and bottom
pole (3) sections MUST
align to correctly position
elevator system toward
playing surface.
IMPORTANT!:
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-
1/2" BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
CAUTION!
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM) MINIMUM
OVERLAP.
NOTE:
2
2
3
3