Hand Held Products DOLPHIN 9500 - Manual (Page 15)

Terminal Setup
Quick St
d the Hand Held
initial serial download,
the terminal software and configuration are m naged automatically over the wireless
network.
Software Management section before
proceeding.
Configuring the Manager
The first step is to configure the Twin Client Manager to meet site-specific requirements,
and then prepare it for the automatic management of the terminal software and IP
addresses. This simple procedure will require only a few minutes to complete.
Setting the Emulation
Click on
Start
,
Programs
,
PowerNet
, and
Twin Client Manager
. Select the
S
art
This section describes how to prepare the Twin Client Manager an
Products terminal for a Telnet session with the host. Following an
a
Note:
Hand Held Products terminals are normally delivered with Hand Held Products
files pre-installed. However, if the terminal does not have those files installed,
refer to instructions at the end of the
ettings
menu as shown below.
Click on
Emulation
, select the desired emulation, and click on
OK
.
Supported Equipment Manual
• January, 2006 2-5