haier 311209J User Manual
Hot melt dispense guns, Instructions - parts
Advertising
311209J
Instructions - Parts
Hot Melt
Dispense Guns
For dispensing non-flammable hot melt thermoplastic sealants and adhesives.
3500 psi (24.1 MPa, 241 bar) Maximum Working Pressure
See page 2 for model information.
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
TI7702b
TI7700b
Bottom feed model
Top feed model
Advertising
Table of contents
Document Outline
- Models
- Warnings
- Installation
- Connect Heated Hose
- Connect Electrical Cable
- Ground the System
- Pressure Relief Procedure
- Trigger Lock
- Operation
- Heatup
- Dispensing
- Shutdown
- Troubleshooting
- Service
- Install New Heater Cartridge(s), RTD Sensor, or Switch
- Inspection Frequency
- Adjust Needle Assembly
- Service Valve Stem and Seal
- Notes
- Parts
- Accessories
- Technical Data
- Graco Standard Warranty
- Graco Information