Maintenance – Homelite UT10927A User Manual

Page 23

Advertising
background image

Page 23

6. Lay out the saw chain in a loop and straighten any

kinks. The cutters should face in the direction of chain
rotation. If they face backwards, turn the loop over.

See

Figure 45.

7. Place the chain drive links into the bar groove as

shown in figure 46.

8. Position the chain so there is a loop at the back of the

bar.

9. Hold the chain in position on the bar and place the loop

around the sprocket.

10. Fit the bar flush against the mounting surface so that

the bar studs are in the long slot of the bar.

Note: When placing the bar on the bar studs ensure
that the adjusting pin is in the chain tension pin hole.

CUTTERS

CHAIN ROTATION

CHAIN DRIVE LINKS

BAR

GROOVE

CHAIN DRIVE LINKS

ADJUSTING PIN

BAR STUDS

GUIDE BAR

PLATE

CLUTCH

COVER

SPROCKET

Fig. 44

Fig. 45

Fig. 47

Fig. 46

MAINTENANCE

Advertising