Battery, Maintenance – HTC Z5426 User Manual

Page 36

Advertising
background image

English

-36

MAINTENANCE

Battery

your mower is equipped with a maintenance free

battery and does not need servicing. However,

periodic charging of the battery with an automotive

type battery charger will extend its life.

Keep battery and terminals clean.

Keep battery bolts tight.

Recharge at 6-10 amperes for 1 hour

To clean battery and terminals
Corrosion and dirt on the battery and terminals can

cause the battery to “leak” power.
1. Open the terminal access doors.
2. Disconnect BLACK battery cable first, then the

RED battery cable and remove the battery from the

machine.

3. Rinse the battery with plain water and dry.
4. Clean terminals and battery cable ends with wire

brush until shiny.

5. Coat terminals with grease or petroleum jelly
6. Reinstall battery.

Replacing battery
1. Lift seat and rotate forward.
2. Remove the red terminal guard.
3. Using two ½" wrenches disconnect BLACK battery

cable then RED battery cable.

4. Using a

7

/

16

" wrench, remove the terminal guard.

5. Carefully remove the battery from the mower.
6. Install new battery with terminals in the same

position as the old battery.

7. Reinstall the terminal guard.
8. First connect RED battery cable to positive (+)

battery terminal with hex bolt and hex nut.

9. Connect BLACK grounding cable to negative (-)

battery terminal with remaining hex bolt and hex

nut.

10. Tighten securely.
11. Close terminal access door.
12. Lower seat.

Always use protective glasses

when handling the battery.

IMPORTANT INFORMATION
Do not attempt to open or remove caps

or covers. Adding or checking level of

electrolyte is not necessary.
Always use two wrenches for the terminal

screws.

WARNING!
Do not short battery terminals by

allowing a wrench or any other

object to contact both terminals at

the same time. Before connecting

battery, remove metal bracelets,

wristwatch bands, rings, etc.
Positive terminal must be

connected first to prevent sparks

from accidental grounding.

CZ-22

1. Terminal guard
2. Terminal access doors
Battery installation

1

2

Advertising
This manual is related to the following products: