HP 339820-002 - Manual (Page 60)

Updating the firmware 60
The update process has three updates—Loading Application Firmware, Loading Graphics Chip,
and Loading System Data. You see a progress bar for each of those three updates. The firmware
update is not done until all of the updates have been loaded. When the firmware is updated, the
following message indicating "Update Complete" is displayed.
e. Click Done.
3. Update the attached interface adapter firmware (" Updating the interface adapter firmware " on page
60 ).
4. Power off the cascaded console switch.
5. Disconnect the local KVM cables from the cascaded console switch.
6. Connect the local port KVM cables to the main console switch.
7. Power on the main console switch.
8. Power on the cascaded console switch.
Updating the interface adapter firmware
There are two ways to update the interface adapter firmware, simultaneously (" Updating the interface
adapter firmware simultaneously " on page 60 ) and individually (" Updating the interface adapter
firmware individually " on page 60 ). The servers attached to the interface adapters must be powered on
while updating the firmware.
Updating the interface adapter firmware simultaneously
1. From the Main dialog box, click Commands>IA Status. The IA Status dialog box is displayed.
2. Select PS/2 or USB, then click Upgrade. The IA Upgrade dialog box is displayed.
3. Click OK to save settings.
4. Press the Esc key to return to the Main dialog box. The OSD indicators are displayed as yellow
while the upgrade is in progress. The indicators change to red and then to green when the upgrade
is complete.
NOTE: Wait until the OSD indicators are displayed as green before continuing.
Updating the interface adapter firmware individually
1. From the Main dialog box, click Commands>Version. The Version dialog box is displayed.