Printhead problem, Previously used genuine hp cartridge – HP PHOTOSMART PLUS B209 User Manual

Page 111

Advertising
background image

Previously used genuine HP cartridge

Solution: Check the print quality of the current print job. If it is not satisfactory, try
cleaning the printhead to see if that improves the quality.

To clean the printhead from the HP Photosmart Software

1.

Load letter, A4, or legal unused plain white paper into the main input tray.

2.

In the HP Solution Center, click Settings.

3.

In the Print Settings area, click Printer Toolbox.

NOTE:

You can also open the Printer Toolbox from the Print Properties

dialog box. In the Print Properties dialog box, click the Features tab, and
then click Printer Services.

The Printer Toolbox appears.

4.

Click the Device Services tab.

5.

Click Clean the printhead.

6.

Follow the prompts until you are satisfied with the quality of the output, and then
click Done.
There are two stages of cleaning. Each stage lasts about two minutes, uses one
sheet of paper, and uses an increasing amount of ink. After each stage, review
the quality of the printed page. You should only initiate the next phase of cleaning
if the print quality is poor.
If print quality still seems poor after you complete both stages of cleaning, try
aligning the printer. If print quality problems persist after cleaning and aligning,
contact HP support.

Follow the prompts on the display or computer screen to continue.

NOTE:

HP recommends that you do not leave the ink cartridge outside of the

printer for an extended period of time. If a used cartridge is installed, check the
print quality. If it is not satisfactory, run the cleaning procedure from the toolbox.

Cause: The genuine HP ink cartridge was previously used in some other product.

Printhead problem

Try the following solutions.

Solution 1: Reinstall the printhead

Solution 2: Contact HP support

Solution 1: Reinstall the printhead

Solution: Check to make sure the printhead is installed and the ink cartridge access
door is closed.
Reinstall the printhead.

To reinstall the printhead

1.

Make sure that the product is turned on.

2.

Open the ink cartridge door.

Chapter 12

108

Solve a problem

Solve a problem

Advertising
This manual is related to the following products: