FUNAI EC520E - Manual (Page 11)

– 11 – EN
0C28
CONNECTING TO EXTERNAL INPUT JACKS
When you watch a program recorded on another
source (VCR or video camera), use the Audio/Video
input jacks on the front panel.
Connect the Audio/Video output
jacks of another source to the
AUDIO L/R and VIDEO jacks of
this unit. Then press SELECT until
“AUX” appears on the screen.
NOTE:
• When you connect a monaural VCR to this unit,
connect the Audio output jack of the monaural
VCR (another source) to the AUDIO L input jack
of this unit. The audio will output in both L and R
channel equally.
VIDEO L–AUDIO–R
VIDEO L–AUDIO–R
[Another source]
To the
audio out-
put jacks
Audio/Video
cables
(not supplied)
etc.
To the video
output jack
[Front of the unit]
AUX
[Fig. 5]
CONNECTING TO AN AMPLIFIER EQUIPPED WITH DIGITAL
INPUT JACKS, MD DECK OR DAT DECK (for DVD only)
Use an audio coaxial digital cable available at retail for the audio connections.
NOTES:
• The audio source on a disc in a 5.1 channel Dolby Digital surround format cannot be recorded as digital
sound by an MD or DAT deck.
• Be sure to turn off the power to all components in the system before connecting another component.
• Refer to the Owner's Manuals for the components to be connected to the unit.
• Set DOLBY DIGITAL to OFF for audio output in the setup mode. Playing a unit using incorrect settings
may generate noise distortion and may also damage the speakers. (See page 28 to set DOLBY DIGITAL to
OFF.)
COAXIAL ANT.
Amplifier equipped with digital
input jacks, MD deck,
DAT deck, etc.
To COAXIAL DIGITAL
AUDIO INPUT jack
To DIGITAL AUDIO OUT
(PCM/BITSTREAM)
COAXIAL jack
(only DVD AUDIO OUT)
[Fig. 6]