Fairchild CAM/CCD-4KCL.TDI - Manual (Page 15)

Notes:
• Exterior overshield is connected to the shells of the connectors on both ends.
• 3M part 14X26-SZLB-XXX-0LC is a complete cable assembly, including connectors.
• Unused pairs should be terminated in 100 ohms at both ends of the cable.
2.3 Power Supply
The camera uses a single voltage input, normally set to 12 Volts @ 0.45 Amps typ.
Ripple and noise is required to be < 20 mV RMS.
Power is supplied through a Hirose connector.
When installing the mating connector, be sure to line up the slots. This action will
assure that you will not bend any of the pins.
Hirose HR25-7TR-6P Receptacle
Pin # Description
1 +12V
2 +12V
3 NC
4 GND
5 GND
6 NC
Fairchild Imaging • CAM/CCD 2KCL.TDI & CAM/CCD-4KCL.TDI Line Scan Camera User’s Manual • Rev C• 15 of 30