Fisher-Price DORA JEEP WRANGLER M3576 - Manual (Page 13)

13
B
e IMPORTANT INFORMATION S INFORMACIÓN DE IMPORTANCIA f RENSEIGNEMENTS IMPORTANTS
M3576pr-0726
ASSEMBLY F
20
• Insert a #10 x 1,9 cm screw into the rear edge of the seat. Tighten
the screw.
• With the seat at an angle, insert the tabs on the front edge of the
seat into the slots in the foot-well wall A .
• Push down firmly on the edge of the seat above each tab to snap
the tabs into the slots B .
• Rotate the back of the seat down C to snap the seat back tabs
into the slots in the vehicle. Push down firmly on the seat back.
19
Seat
Seat Back
Tabs
Slot
Tabs
A
B
C
PUSH
HERE
21
• Using safety scissors, cut the plastic tie holding Map in the clip.
• Fit the clip to the windshield.
• Insert a #10 x 1,9 cm screw into the clip and tighten.
• Replace Map into the clip.
Note to Retailer: Do not remove the plastic tie. Simply remove Map
from the clip. Assemble the clip to the windshield and replace Map in
the clip.
• Using safety scissors, cut the plastic tie holding Backpack in the
holder. Remove Backpack from the holder.
Note to Retailer: Do not remove the plastic tie. Simply lift Backpack
from the holder and assemble the holder to the top edge of the
vehicle. Replace Backpack in the holder.
• Fit the holder to the top edge of the vehicle as shown.
• Insert two #10 x 1,9 cm screws into the holder. Tighten the screws.
22
Map
Clip
Backpack
Holder
SIDE VIEW
BACK VIEW