Furuno NETCONTROLLER B042-008 - Manual (Page 29)

3. INITIAL SETTINGS
3-3
Entering transducer data by transducer model number
Note 1: If you are continuing from paragraph 3.1 go to step 2.
Note 2: If you have already entered transducer settings and to reconfirm them turn on the
power while pressing any key.
1. Turn on the power.
2. Press any key to show the following menu.
XDCR SELECT : XDCR TYPE
[HIGH]
CONNECTION
: NOT CONNECTED
FREQ : ---kHz
TRANSDUCER : ----
TAP : --
[LOW]
CONNECTION
: NOT CONNECTED
FREQ : --- kHz
TRANSDUCER : ----
TAP : --
POWER REDUCTION : OFF
[-/+]: Change setting, Turn OFF to exit
XDCR SELECT INSTALLATION DEMO
Installation main menu
Note: XDCR SETTING is set to “XDCR TYPE” at the default setting.