Fisher-Price JEEP WRANGLER 78490 - Manual (Page 12)

Assembly
12
10
• Face the front of the vehicle.
• Apply labels to the vehicle body grille as shown. Make
sure the areas where the labels will be applied are
clean and dry. For best adhesion, avoid applying the
labels more than once.
28
• Fit the lens tabs on the back of a lens assembly into the
headlight slots in the grille.
• Press firmly to snap the lens assembly into the grille.
• Repeat this procedure to snap the other lens assembly
into the grille.
Grille
Tabs
Slots
11
• Fit the wide notch in the side of a headlight lens under
the wide tab on a lens guard.
• Press firmly on the inside of the headlight lens to snap it
into the lens guard.
• Repeat this procedure to assemble the other headlight
lens to the remaining lens guard.
Lens
Wide Notch
Wide Tab
Lens Guard
9
8
Steering Wheel
• Fit the steering wheel cap into the center of the steering
wheel with the screw holes aligned.
• Insert two #8 x 1" screws as shown.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Steering
Wheel
Cap