Fantom Vacuum FM430H - Manual (Page 6)

OPERATING INSTRUCTIONS
4
3. To use the flexible hose with
the dusting brush, hold the
hose in one hand and with the
other, pull out the dusting brush
and turn clockwise to lock in
place. (fig. 4)
Warning: Always unplug from
electrical outlet before opening the dust
cup (container).
Note : HEPA dust cup filter must be
used when operating the hand vacuum.
Using The Unit As A Hand
Vacuum
1. Insert the dusting brush/hose
connector into the brush chamber
exhaust port. Lock the flexible hose in
place by clipping the hose into the
hose holder. (fig. 1)
Cleaning With the Hose
CAUTION: The Hand Vacuum is
a very powerful unit. Make sure
that you hold it firmly, otherwise it
can slip out of your hand and
cause injury.
To use the hand vacuum with only the
hose and the dusting brush or crevice
tool:
1. Rotate the brush cover by pushing on
the brush cover release button until it
clicks in place. (fig. 2)
2. Remove the flexible hose from the
brush chamber exhaust port and take
the hose out from the hose holder.
(fig. 3)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
3. To use the flexible hose with
the crevice tool, make sure that
the brush is in the storage
position and insert the crevice
tool into the opening of the
hose. (fig. 5)
Fig. 5
OPERATING INSTRUCTIONS
Cleaning & Changing the
HEPA Dust Cup Filter
Warning: Always unplug the unit from
electrical outlet before opening the Dust
Cup (container).
Important: Do NOT use the HEPA filter
cartridge without the debris screen in
place.
Warning : After each Use - Always
remove the Filter Debris Screen from the
HEPA Dust Cup Filter, then vigorously
“TapClean” HEPA Filter until no more
dust can be removed.
2. To open the Dust Cup (container),
push button and remove the Dust
Cup (container ). (Fig. 7)
Dust cup release button
Fig.7
3. Rotate the lower dust cup clockwise
to separate it from the filter chamber.
Empty and clean the dust cup. (fig. 8)
IMPORTANT, Please Note : The
“TapClean” HEPA Dust Cup Filter &
Debris Screen will stop most of the tiniest
dust particles from re-entering the air you
breathe. In fact it stops 99.97% of all
particles as small as 0.3 microns - many
times smaller than a human hair!!!
Because of this incredible filtration
performance, the HEPA Dust Cup Filter
will quickly accumulate, inside the white
filter folds, many fine dust particles that
are difficult to see but which will eventually
block or reduce your suction power - if not
cleaned properly. Clean the HEPA Filter
and Debris Screen after each use as
described in this section.
Fig.8
Filter
Chamber
Dust
Cup
4. Remove the HEPA Filter from the filter
chamber. (fig. 9)
5. Separate the debris screen from the
HEPA filter cartridge by grasping the
debris screen with one hand and the
filter frame with the other and pull
apart. (fig. 10)
Fig. 9
Filter
Chamber HEPA
Filter
Debris
Screen
Fig. 10
1. To remove the dust cup (container),
hold the unit in the upright position
to prevent the dust from falling out
of the dust cup. (Fig. 6)
Fig. 6
HEPA
Filter
5