Fostex PM-1MKII - Manual (Page 5)

Once the studio monitors have been placed in their final location, it is time to proceed to connecting your
made using XLR or TRS connectors. The gain control on the back of the monitor allows continuously variable
adjustments to match most input types from -10dBV to +4dBu. The input is electronically balanced and is
compatible with unbalanced sources, although this may require an adapter. The connection of the PM-1 MK
Ⅱ
to the console/digital workstation should be done in the following order.
Setup Instructions continued
Back Panel Overview
Step 1: Make sure that all equipment has been powered down.
Step 2: Confirm that all gain controls, on the monitor and the source, are set to the minimum setting.
Step 3: Connect the source to the PM-1 MK
Ⅱ monitor.
Step 4: Power up the all source equipment and then turn on the PM-1 MK Ⅱ last.
Step 5: Set the gain of both monitors at medium setting and slowly bring up the gain of the console.
Step 6: Adjust the gain of both monitors for balance and for best signal to noise ratio
Once the above steps have been completed, you are ready to use your PM-1 MK Ⅱ monitors. It is
recommended that you now play some familiar audio material and make any final adjustments, as far
as placement or level, to get the optimum performance in your monitoring environment.
1. XLR & TRS Combination Input
This input is an electronically balanced input and
is compatible with both -10dBV and +4dBu
signals.
2. Continuously variable gain control
This control adjusts the input level to the internal
amplifiers.
3. Heatsink
The heatsink dissipates heat from the amplifier. It
is important the heatsink receives proper
ventilation and is not placed near any sources of
heat.
4. Power Switch
Turns power to the amplifier section on or off.
On - position is the spot side.
The apparatus shall be used in an open area.
5. Standard IEC Power Input
This power terminal should be used with a
properly grounded three pin power cable, such as
the one provide with the product.
p-5
WARNING:
To reduce the risk of fire or electrical
shock, do not expose this equipment to rain or
moisture. Do not remove cover.No user serviceable
parts inside.Refer servicing to qualified personal.
PM-1 MK Ⅱ studio monitors to the mixing console or digital workstation. Connection to the PM-1 MKⅡ can be
AVIS: RISQUE DE CHOC ÉLECTRIQUE
NE PAS OUVRIR
INPUT
G A I N
M A X
O F F
POWER
AC IN
1
2
3
4
5
PM-1 MK