FUJITSU M8000 - Manual (Page 183)

setdate(8)
System Administration 161
NAME setdate - set the date and time of XSCF
SYNOPSIS setdate [ [-q] -{y|n}] [-u] -s date
setdate -h
DESCRIPTION The setdate(8) command sets the date and time of XSCF.
If the local date and time are specified, they are set following conversion to
coordinated universal time (UTC).
After the command executed, XSCF will be reset automatically.
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXTENDED
DESCRIPTION
■ When the command is executed, a prompt to confirm execution of the command
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
■ In the M8000/M9000 servers, the setting automatically reflected to the standby
XSCF. When there is a defect on the standby XSCF, it leads to an error and the
setting will be reflected to the active XSCF only.
■ If the XSCF is used as an NTP server, change the XSCF time, and synchronize the
domain times with the XSCF time. The XSCF time is applied to a domain during
either of the following operations:
-h Displays usage statement. When used with other options or
operands, an error occurs.
-n Automatically answers "n" (no) to all prompts.
-q Suppresses all messages to stdout, including prompts.
-s date Sets date and time. date can be specified in either of the following
formats:
YYYY.MM.DD-hh:mm:ss Specifies date in the format of
"year.month.day-
hour:minute:second."
MMDDhhmmYYYY.ss Specifies data in the format
"MonthDayHourMinuteYear.
second."
-u Specifies time in UTC. When omitted, the local time is specified.
-y Automatically answers "y" (yes) to all prompts.