FUJITSU M8000 - Manual (Page 501)

unlockmaintenance(8)
System Administration 479
NAME unlockmaintenance - forcibly release the locked status of XSCF
SYNOPSIS unlockmaintenance [ [-q] -{y|n}]
unlockmaintenance -h
DESCRIPTION unlockmaintenance (8) command releases the locked status of XSCF forcibly.
Normally, while the maintenance command addfru(8), deletefru(8), or
replacefru
(8) is in execution, XSCF is in the locked status. After the command
complete, the lock is released. However, in case an error such as LAN disconnection
occurred while executing any of the maintenance command, the XSCF lock may
become unable to release. In such a case, you can execute the
unlockmaintenance
(8) command to forcibly release the locked status of XSCF.
Privileges You must have fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXTENDED
DESCRIPTION
When the command is executed, a prompt to confirm execution of the command
with the specified options is displayed. Enter "y" to execute the command or "n" to
cancel the command.
EXAMPLES EXAMPLE 1 Unlocks the maintenance lock status.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-n Automatically answers "n" (no) to all prompts.
-q Suppresses all messages to stdout, including prompts.
-y Automatically answers "y" (yes) to all prompts.
XSCF> unlockmaintenance
This command unlocks the maintenance lock which prevents the multiple
execution of maintenance commands.
*Never* use this command, except when the lock state remains by some reason.
Careless execution of this command causes serious situation because it
interrupts the running command and XSCF might not be able to recognize the
parts.
Continue? [y|n] :y