FUJITSU fi-4640S - Manual (Page 46)

4-6
CHECK
Is the scanner the last
device of the SCSI chain?
Is the SCSI ID set
correctly?
Is the baud rate of the
system 4800 bps?
(When you use the Fujitsu
video interface board.)
The termination should be
turned off via the front panel.
Set the SCSI ID correctly.
Use the operator panel to
change the ID.
NO
NO
YES
YES
NO
NO
YES
YES
Contact the manufacturer’s
authorized service center to
set the correct baud rate.
The scanner works normally.
Contact the manufacturer’s authorized
service center.
Is the CHECK indicator lit?
Is an Alarm displayed?