Fisher-Price P1384 - Manual (Page 26)


Problem Solution
Receiver signal L.E.D. flashes Receiver is out of range of transmitter. Move receiver closer to transmitter.
Note: Range varies depending on surrounding conditions such as noise
levels, physical obstructions and signal interference. Under optimal
conditions, the range is up to 800 feet.
Transmitter power is off. Turn transmitter power on.
Loose power cord connection and transmitter power is off.
Check transmitter power cord plug-to-outlet connection.
No power to wall outlet and transmitter power is off. Make sure light
switch that controls power flow to wall outlet is on.
Power is off because circuit breaker for room is off. Make sure house
fuses and circuit breakers are on.
Receiver power/battery
L.E.D. does not light
Receiver power is off. Turn receiver power on.
Batteries in receiver are weak or dead. Use AC adaptor as power source
and to charge the battery.
Power is off because circuit breaker for room is off. Make sure house
fuses and circuit breakers are on.
No power to wall outlet and power is off. Make sure light switch that
controls power flow to wall outlet is on.
Receiver power/battery
L.E.D. flashes
Batteries in receiver are weak or dead. Use AC adaptor as power source
and to charge the battery.
Transmitter power L.E.D. does
not light
Transmitter power is off. Turn transmitter power on.
Loose power cord connection and transmitter power is off.
Check transmitter power cord plug-to-outlet connection.
No power to wall outlet and transmitter power is off. Make sure light
switch that controls power flow to wall outlet is on.
Power is off because circuit breaker for baby’s room is off. Make sure
house fuses and circuit breakers are on.
You can hear conversations or
sounds from other homes
There is signal interference due to other nursery monitors on same
channel or cordless telephone use. The monitor should automatically
find a new channel to avoid interference.
Receiver is not picking up sounds
from transmitter
You may need to pair the receiver and transmitter. Turn over the master
receiver and press the pairing button with a pen. Then, turn over the
transmitter and press the pairing button with a pen. The signal L.E.D.
on the receiver will flash and you will hear a tone. Repeat this procedure
to pair the second receiver.
Problems & Solutions