FORD 1999 F-150 - Manual (Page 217)

Fill to 6–14 mm (1/4–9/16 inch) below bottom of filler hole.
4 Ensure the correct automatic transmission fluid is used for a specific
application. Check the container to verify the fluid is MERCON
௡
approved. Transmission fluid requirements are indicated on the dipstick
handle. Refer to the Scheduled Maintenance Guide.
Do NOT use any non-approved automatic transmission fluid for an
application specifying MERCON
௡. Use of a non-approved fluid may cause
internal transmission component damage.
5 Indicates only approximate dry-fill capacity. Some applications may
vary based on cooler size and if equipped with an in-tank cooler. The
amount of transmission fluid and fluid level should be set by the
indication on the dipstick’s normal operating range.
6 Add 118 ml (4 oz.) of additive friction modifier C8AZ-19B546-A, Ford
specification EST-M2C118–A, for complete fill of 8.8 inch and 9.75 inch
Traction-Lok axles.
7 Add 236 ml (8 oz.) of additive Friction Modifier C8AZ-19B546-A, Ford
Specification EST-M2C118-A, for complete fill of 10.25 inch Traction-Lok
axles.
8 In-vehicle refill: approximately 3.1L (6.5 pints).
LUBRICANT SPECIFICATIONS
Item
Ford part
name or
equivalent
Ford part
number Ford
specification
Front axle
(4X4)
Motorcraft SAE
75W90 Axle
Lubricant XY-75W90-QL WSP-M2C201-A
Rear axle
Motorcraft SAE
75W140 High
Performance
Synthetic Rear
Axle Lube
1
F1TZ-19580-B WSL-M2C192-A
Brake fluid and
clutch fluid
High
Performance
DOT 3 Motor
Vehicle Brake
Fluid C6AZ-19542-AB ESA-M6C25-A
and DOT 3
Capacities and specifications
217