Fisher-Price GO DIEGO GO K6673 - Manual (Page 4)

• Fit the tabs on the wheel cap into the slots in the
wheel hub. Push to "snap" the wheel cap in place.
• Repeat this procedure to attach the other wheel cap
to the other wheel hub.
• Fit two pedal hubs onto the pedal axle tabs. Make sure
the tabs fi t into the slot in each pedal hub.
• While holding the pedal hubs on the pedal axle,
insert the pedal axle into the hole in the center of the
front wheel.
• Press the pedal hubs into the center of the front wheel
until they are fl ush with the surface of the front wheel.
• Repeat this procedure for the other two pedal hubs on
the other side of the front wheel assembly.
• Fit the cap nut on the end of the straight axle.
• Tap the cap nut with a hammer. Gently pull the rear
wheel to be sure the cap nut is securely attached
to the straight axle.
Hint: You may need the help of another adult to hold
the other end of the straight axle in place.
Wheel Hub
Wheel Cap
Pedal Hub
Pedal Hub
5
7
6
4
Pedal Axle Tab
Assembly
• Place the front wheel assembly between the fork arms.
Make sure the pedal axle fi ts into the groove at the
bottom of each fork arm.
• Place a fork cover over the pedal axle on one fork arm.
• Insert two #8 x ¾" screws into the fork cover
and tighten.
• Repeat this procedure to attach the other fork cover
to the other fork arm.
Fork Arms
Pedal Axle
Groove
Fork Cover
Front Wheel
Assembly
8