Flymo EASICUT 500CT - Manual (Page 4)

Power tool use and care
1.
Know how to stop the product quickly in an emer-
gency.
2. Never hold the product by the guard.
3. Never operate the product with damaged guards or
without guards in place.
4. Do not use stepladders whilst operating the product.
5. Use the product only in daylight or good artificial
light.
6. Avoid operating your product on a wet hedge, where
feasible.
7. Keep hands and feet away from the cutting means at
all times and especially when switching on the motor.
8. Remove the battery pack :-
- before leaving the product unattended for any period;
- before clearing a blockage;
- before checking, cleaning or working on the product;
- if you hit an object. Do not use your product until you
are sure that the entire product is in a safe operating
condition;
- if the product starts to vibrate abnormally. Check im-
mediately. Excessive vibration can cause injury.
- before passing to another person.
Maintenance and storage
1.
Keep all nuts, bolts and screws secure to be sure the
product is in safe working condition.
2. Replace worn or damaged parts for safety.
3. Be careful during adjustment of the product to pre-
vent entrapment of the fingers between moving
blades and fixed parts of the machine.
4. After use the product should be stored using the
blade cover provided.
5. Store in a cool dry place and out of reach of children.
Do not store outdoors.
6. Allow the product to cool for at least 30 minutes be-
fore storing.
Battery
Cordless Battery Powered Products require special care.
1.
AVOID ACCIDENTAL STARTING
KEEP HANDS AND FINGERS AWAY FROM THE
SWITCH LEVER WHILE CARRYING THE PROD-
UCT.
2. Always charge the product indoors and store in a
cool dry place - out of the reach of children.
3. Use the charger with standard domestic household
electrical outlets only.
4. Do not abuse the charger or charger cord.
5. Do not use the charger if the charger or cable is dam-
aged.
6. Do not charge the battery or use the unit in an explo-
sive or corrosive environment. Avoid areas where
flammable liquids or gases are present to avoid cre-
ating a fire or explosion.
7. Do not attempt to repair the unit including the battery.
8. Do not insert any object into the motor area. Keep
free of debris to avoid overheating.
9. Do not incinerate or mutilate the battery. Batteries
contain hazardous chemicals. Dispose of properly.
Assembly of Handguard.
1. Insert Handguard into slot as illustrated in figure A,
ensuring that it is securely located.
DO NOT USE THE PRODUCT WITHOUT FITTING
THE HANDGUARD
Assembly
A
Battery Care
1. If over a period of time the battery quickly runs down
after a full 5-6 hour charging period, a replacement
battery is needed.
2. There will be some charge present in the battery but
to ensure maximum running time, recharge your prod-
uct for 5-6 hours before use.
3. To prevent permanent battery damage, never store in
a discharged condition.
4. Contact your local approved service centre/dealer/dis-
tributor for a replacement battery and for safe disposal
of your old battery.
5. Battery
18 Volt 1.3 Amp/Hour
"High Power"
No maintenance required
• IMPORTANT
DISPOSE OF YOUR OLD BATTERIES SAFELY
DO NOT CUT OPEN, BURN OR INCINERATE.
Winter Storage
1. Fully charge for 5-6 hours before winter storage.
2. Avoid extended storage without re-charge.
3. Store in a cool dry place.
For further information on Battery replacement contact
Husqvarna UK Ltd. Customer Service direct:-
Telephone : 0844 844 4558 UK
1800 882 350 ROI
Fax : 01325 302530
Battery