Fisher-Price 79008 - Manual (Page 3)

6
ASSEMBLY
• Insert a screw through the outside of each plastic cover and tighten with a
Phillips screwdriver. Do not over-tighten.
• Pull up on the seat back wire to be sure it is secure. If you can remove
either end of the seat back wire, you have not assembled it correctly.
Remove the screws, re-read and repeat Assembly steps 3 and 4.
4
#8 x 32 Nut
Pull Up
Protruding Side
3
5
• Position the footrest wire so that the soothing unit is upright.
• While flexing the base wires toward each other, hook the footrest wire
onto the ends of the base wires.
• Push the footrest wire down completely, below the red marks on the
base wires.
ASSEMBLY
2
Base Wire
Red Mark
Base Wire
Soothing
Unit
Footrest
Wire
Red
Mark
• Position the seat back wire with the toy bar sockets upright.
• Fit the seat back wire completely onto the base wires, so that each end
covers the red mark on each base wire.
• Make sure the plastic covers on the seat back wire cover the red
marks on the base wire.
Red
Mark
Plastic
Cover
Plastic
Cover
Base
Wire
Toy Bar
Socket
Seat Back
Wire
• Fit the nut (so that the protruding side is
outward) into the hexagonal opening on
the inside of each plastic cover.