Force10 Networks C-Series User Manual
Page 4
4
101-00310-01
4
Continue sliding the line card until you feel the connectors engage with the chassis backplane.
5
Rotate the levers towards the card to seat the backplane connectors and line card in place. Push on
the knurled section of the levers until the thumb tabs pop up and lock the unit in place. See
and
Figure 4 Close the levers.
Figure 5 Press the knurled section of the lever.
Caution: Installing a card without fully engaging the locking mechanism will damage the
EMI seal on the card below it when that card is inserted.
6
Install a blank panel in all slots that do not have a line card and secure it with the screws provided.
Installation Notes: The blank panels for RPMs and line cards are different sizes (RPM
blanks are smaller); be sure that blank panels are installed in the correct slots.
Step
Task