Meridian Audio 568 - Manual (Page 75)

Configuring the digital surround processor without a computer
68
To choose the distance units
You can choose to display and enter distances in either feet and
inches, or metres.
To change the distance units:
● Put the digital surround processor into standby by pressing
Off (front panel or remote).
● Press and hold the V key on the front panel for at least five
seconds.
The display shows the distance
units:
Metric
or:
Imperial
To start the calibration procedure
● Put the digital surround processor into standby by pressing
Off (front panel or remote).
● Press and hold the Off key on the front panel for at least five
seconds.
The display shows:
Calibration
If you have an on-screen display it shows:
After a few seconds the display
shows:
Left +0.0
For more detailed information about this and the other
calibration tests see the following sections.