Fortress Technologies CRIMESTOPPER FS-10 - Manual (Page 10)

10
OPTION PROGRAMMING Cont.
6. DOUBLE UNLOCK PULSE
The unit will send 2 Unlock Pulses when the #2 Unlock button is pressed. This feature may be required for
interfacing this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are
found on some Nissan, VW, Toyota, and Lexus vehicles.
7. DISARM WITH TRUNK POP
Controls whether the Alarm System will Disarm when the Trunk Pop feature is used. When the Option 7 is
turned on, the Alarm Disarms when Popping trunk or using an AUX device controlled by the Gray output wire.
8. DOOR LOCK/UNLOCK PULSE TIME
Controls the amount of time (0.75 sec. or 3 sec.) for the Lock and Unlock Pulse. The 3 sec. setting may be
required for 1980’/90’s European Vehicles that require a long pulse to do Vacuum door lock systems.
9. ACTIVE, PASSIVE, or FULL TIME CARJACK PROTECTION
This feature controls the type of Carjack protection the alarm will provide. There are 3 selections: Button 1
(Lock) = Active protection. Button 2 (Unlock) = Active and Passive protection. Button 3 = Full-Time
protection. Option number 10 must be enabled to allow Carjack functions to operate.
10. CARJACK FEATURES
This option controls the unit’s Car Jack features. Enable or Disable Carjack (Turn ON or OFF) with this option.
11. PARKING LIGHTS ON WITH DISARM
Keeps Parking lights ON 30 seconds instead of 2 flashes when system is disarmed. This is for added security
and to assist in locating your vehicle in a crowded parking lot or structure. Light will stay on for 30 Sec. or until
Ignition is turned on.
12. PASSIVE LOCKS
This option controls whether the doors will lock when Passive Arming occurs. Note: This feature may
increase the risk of locking keys in the vehicle.