Furuno IB-681 - Manual (Page 38)

28
Set subscriber number at the FELCOM *51* ...#
cisco1601#sh conf
version 11.3
service udp-small-servers
service tcp-small-servers
!
hostname cisco1601
!
enable password *****
!
username land-term password 0 *****
!
interface Ethernet0
ip address 192.168.2.1 255.255.255.0
!
interface Serial0
ip address 192.168.10.10 255.255.255.0
encapsulation ppp
no keepalive
dialer dtr
dialer-group 1
ppp authentication chap
!
ip classless
ip route 0.0.0.0 0.0.0.0 192.168.10.1
ip route 192.168.0.0 255.255.255.0 192.168.10.1
ip route 192.168.1.0 255.255.255.0 192.168.10.1
dialer-list 1 protocol ip permit
snmp-server community public R0
!
line con 0
exec-timeout 0 0
line vty 0 4
password *****
login
!
end
cisco1601#
This example shows only the minimum necessary settings for confirmation. Further
details can be obtained from a Cisco dealer or Cisco’s home page (http://
www.cisco.com).
For other router see its operator’s manual.
Network configuration
• Network configuration depends on application and number of terminals used. Gener-
ally, setup is done on the user’s equipment.
• Setup depends on shipboard network and land network. For details contact the net-
work manager.
• We recommend that identification be exchanged between sender and receiver. Where
required used packet filtering and firewall.
• FURUNO will assume no responsibility for security-related problems.