FUJITSU FMC-16LX FAMILY - Manual (Page 6)

Change even page title here
Chapter 1 Overview
UG-900001-32 - 6 - © Fujitsu Microelectronics Europe GmbH
1 Overview
1.1 Abstract
This user guide describes the basic features of the new FLASH-CAN-100P-M06/FLASH-
CAN2-100P-M06 board. This board can be used with almost all our 16LX microcontroller
series supporting the FPT-100P-M06 package.
1.2 Introduction
The "Flash/CAN100"-board was developed in order to support customers and allow a fast
software design start. Fujitsu emulators require a target system that provides Vcc and GND
as well as an oscillation circuit. Additionally most of Fujitsu’s flash microcontroller support the
burn-in flash programming algorithm.
For the FLASH-CAN-100P-M06 board an IC149-100-114-B5 socket adapter is used. The
suitable emulation probe cable is the MB2132-457.
On the FLASH-CAN2-100P-M06 board a NQPACK100RB socket adapter is assembled.
This requires the MB2132-464 for the connection to the emulator.
This board must only be used for test applications
in an evaluation laboratory environment.
1.3 Connectivity problems of the socket adapter
Some customers experience connectivity problems when connecting the MCU into the
socket adapter. Only the small red screwdriver available in your box should be used to
connect the cover (HQPACK) onto the socket (NQPACK).
If the four screws are not tightening equally, then it may cause a poor contact.
Do not screw the cover too tight (max 0.054 Nm). If you have connectivity problems then
please loosen the screws and tighten again the screws equally.
Do not clean NQPACK, YQPACK, and YQSOCKET with steam. Cleaning material will
contaminate inside of connector.
Customers using the FLASH-CAN-100P-M06 (with IC-149-100-114-B5 socket adapter) do
usually not encounter this problem with the FLASH device.