Fisher M-SCOPE CZ-3D - Manual (Page 7)

5
1. GROUND: Used to electronically cancel the effects
of ground mineralization. Proper use of this control
will minimize false ground signals and insure that the
CZ-3D is operating at its maximum potential in just
about any ground condition including wet ocean
sand.
2. DISC: In the 0 through 6 position the CZ-3D is in
the target ID mode, which is a silent, no-threshold,
motion-discrimination mode of operation with the
ability to identify and then ignore (“reject”) or accept
many kinds of small metal targets. In the AUTOTUNE
position, the CZ-3D is in an all-metal mode. In this
mode, the CZ-3D has a wider and deeper search
pattern, however, it lacks the ability to discriminate
HIPMOUNTING
1. Disconnect the cable from the control housing and
unwind all but the last twelve inches from the stem.
Secure the lower end of the cable with a Velcro strap
at least twelve inches up from the coil.
2. Slide the control housing off the handle by holding
the handgrip with one hand and pulling the housing
towards you with the other hand.
3. Reconnect the cable to the control housing. It is
especially important that the cable connector
be installed tightly to prevent false signals during
hipmount use. Tight, but never tightened with
anything but your hands.
4. Put your belt through the slots on the underside of
the housing.
5. Left handers should wear the housing on their right
hip and right handers on their left hip.
NOTE: If you’re working in shallow water you may want
to hang the control housing around your neck or chest-
mount with Fisher’s Chest Harness. Just make sure
you put it in a heavy plastic bag sealed tightly around
the cable. Remember, the only thing waterproof about
the CZ-3D is the search coil.
CONTROL PANEL