Fisher & Paykel DD60 - Manual (Page 36)

34
Fault codes
How to recognise a fault code
When a fault has occurred, the DishDrawer® will continuously beep every second.
The fault code will be displayed on the wash programme selector.
Each fault code is shown in the following chart.
How to attend to a fault code
1 Press the / button briefly to stop the beeping.
2 Press the / button to turn the DishDrawer® off. Wait a few seconds.
3 Press the / button to turn the DishDrawer® back on.
Has the fault code disappeared? > YES > You can continue to use your DishDrawer®.
NO
4 Note down the fault code.
5 Unplug the DishDrawer® or turn it off at the power supply.
6 Check the chart overleaf and try correcting the fault where possible, following the instructions in
the ‘What to do’ column.
Has the fault code disappeared? > YES > You can continue to use your DishDrawer®.
NO
7 Unplug the DishDrawer® or turn it off at the power supply.
8 Call your Authorised Service Centre or Customer Care and advise them of the fault code.
This information will help them respond to your request.