FUJITSU TX300 - Manual (Page 70)

70 Options Guide TX300 S6
HDD extension box Accessible drives and LSD/LSP
7.4.1.1 Installing Multibay 2
When installing Multibay 2, proceed in a similar way as for installing Multibay 1.
See
section "Installing Multibay 1" on page 64 on how to connect the SATA
cable to the DVD drive and connect the PSU adapter cable to the power cable.
Ê Push Multibay 2 fully into bays 2 and 3 until the EasyClick rails lock in place.
Ensure that no damage is caused to the cables.
Ê Remove the fan carrier as described in the chapter "Preparation" on
page 27 .
Ê Remove the cable cover as described on page 85 .
Figure 43: Connecting cables to HDD backplane of Multibay 2
Ê Connect the connector CON.6 of the power cable to the connector X5 of the
HDD backplane (1).
Ê Remove the cable tie located near connector CON.4 from the I
2
C cable.
Ê Connect the I
2
C cable connector CON.4 to the LSP/LSD module (see the
cabling plans in the Appendix)
Ê Connect the I
2
C cable to the connector X7 of the HDD backplane (2).
1
0