Fire Sense Deluxe Patio Heater PH03-SS - Manual (Page 14)

WARNING: DO NOT attempt to operate heater until you have
read and understood all precautions.
Failure to do so can result in serious personal injury, death and/or
property damage.
Before turning gas supply ON
Your heater was designed and approved for OUTDOOR USE ONLY .
DO NOT use it inside a building, or any other enclosed area.
Make sure surrounding areas are free of combustible materials, gasoline
and other flammable vapors or liquids.
Ensure that there is no obstruction to air ventilation.
Be sure all gas connections are tight and there are no leaks.
Be sure that access panels are clear of debris.
Be sure any component removed during assembly or servicing is
replaced and fastened prior to starting.
Before Lighting
Heater should be thoroughly inspected before each use, and by a qualified
service person at least annually.
If relighting a hot heater, always wait at least 5 minutes.
Our heater is tested for quality assurance.
Ignition attempts should succeed 8 out of 10 attempts.
LIGHTING INSTRUCTIONS
1. Turn the control knob to “OFF” position.
2. Fully open gas valve .
3. Push in gas control knob and turn counterclockwise to “IGNITE”
then to “PILOT” position. This will light the pilot.
If needed, keep depressing and turning control knob counterclockwise
until the pilot lights(you will hear 2 clicking noises).
4. Once the pilot is lit, continue to keep the control knob depressed for
at least 30 seconds. After 30 seconds, release control knob.
5. If pilot does not stay lit, repeat steps 3 and 4.
6. If pilot still does not stay lit, then:
A . Push in gas control knob and turn counterclockwise to “IGNITE” then to
“PILOT”
B . Keep depressing the control knob and put long stick lighter into the ignition
hole on the emitter screen to light the pilot
C . Repeat step 4.
7. Push in and turn control knob counterclockwise to “LOW” position.
Release knob then turn to low. If you want a higher temperature,
push in the control knob and turn counterclockwise to the “HIGH”
position.
Note:The flame pattern at the emitter grid should be visually checked whenever
heater is operated. Normally the burner flame is blue, but a little yellow flame is
acceptable.
If flames extend beyond the emitter grid or there are black spots that have
accumulated
on the emitter grid or reflector, immediately turn off the
patio heater.
The heater should not be operated again until it has been serviced and
repaired by a qualified gas technician.
If you experience any ignition problem, turn off the heater and gas supply, and consult troubleshooting on page 19.
OPERATION
WARNING
FOR YOUR SAFETY:
DO NOT touch or move heater for at
least 45 minutes after use.
Allow emitter and dome to cool before
touching.
WARNING
FOR YOU SAFETY:
If at any time you are unable to light
burner and smell gas, wait 5 minutes
to allow gas to dissipate before
attempting to light heater. If after 1
minute you are unable to light burner,
wait 5 minutes and allow
flammable vapors to dissipate before
attempting to light heater again.