Fire Sense Deluxe Patio Heater PH03-SS - Manual (Page 15)

CAUTION: Avoid inhaling fumes emitted from the heater’s first use.
Smoke and odor from the burning of oils used in manufacturing will
apper. Both smoke and odor will dissipate after approximately
30 minutes. The heater should NOT produce thick black smoke.
Note:
The burner may be noisy when initially turned on. To eliminate excessive
noise from the burner, turn the control knob to the “LOW” position, then
turn the knob to the level of heat desired.
When heater is ON:
Emitter screen will become bright red due to intense heat. The color is
more visible at night. Burner will display tongues of blue flame. These
flames should not be yellow or produce thick black smoke, indicating an
obstruction of airflow through the burner.
Operation Pressure Checked
If the flame is very small, this is because the supply pressure is not enough.
To Light:
1. Turn the control knob to “OFF” position.
2. Wait five minutes before attempting to relight pilot.
3. Repeat steps beginning with step 2 on page 14.
Before Leaving Heater Unattended:
1. Turn the control knob to “OFF” position and turn LPG cylinder to “OFF”
position.
2. Never leave the patio heater unattended while in use.
Shut Down Instructions
1. Push in and turn control knob clockwise to “OFF” position.
2. Turn LPG cylinder valve clockwise to “OFF” position when
heater is not in use.
Note: After use, some discoloration of the emitter screen is normal.
In the Event of Gas Leakage
1. Turn the control knob to “OFF” position.
2. Turn LP cylinder to “OFF” position.
3. Wait 5 minutes to allow gas to dissipate.
4. If odor continues, immediately call gas supplier.
WARNING:
Heater will be hot after use.
Handle with extreme care.
OPERATION