4 setting the scsi id, 5 installing the drivers and software – FUJITSU M3091DC User Manual
Page 27
Advertising

2.3.4 Setting the SCSI ID
This section explains how to set the SCSI ID.
1) Disconnect the power cable from the outlet.
2) Set the device address using the SCSIID switch on the rear of the scanner.
Precautions for setting the device address
Address No.
Description
0 - 7
Can be set
8, 9
If 8 or 9 is set, factory setting (SCSI ID = 5) is used.
3) After setting the SCSI ID number, insert the power cable into the outlet.
2.3.5 Installing the drivers and software
Execute Setup.exe on the supplied setup disks (driver disk 1 and software disk 1) to install the
software and drivers. To use the scanner's operator panel, all software disks must be installed.
C Note
Read Readme.txt on the floppy disk before installing the software.
Advertising