First Act MA215 - Manual (Page 2)

REPLACING THE FUSE
An additional fuse has been enclosed in the fuse
compartment of your amplifier, directly below
the power input. The fuse compartment contains
an active fuse and a replacement. The fuse protects
against power surges. If your amplifier does not
power up as usual, the fuse may need to
be replaced.
If the fuse fails:
1. Turn the amplifier power off.
2. Unplug the amplifier.
3. Detach the power cord and set aside.
4. Carefully insert a flathead screwdriver to
open the fuse compartment. Be careful not
to break the fuse inside.
5. Remove the blown fuse from the inner
(active) slot.
6. Move the new fuse from the outer slot to the
inner slot.
7. Close the fuse compartment.
8. Discard the blown fuse.
Note: If you replace the fuse and the amplifier
still does not power up, have the unit checked by
a qualified repairperson.
SPECIFICATIONS
Output Power:
15 watts RMS
Frequency Range:
75 Hz ~ 10 kHz
Speaker:
8" / 20W / 4 ohms
Input Sensitivity:
26 mV
Power Supply:
See back of amp
Dimensions: (LxWxH)
14" x 13" x 8"
Weight:
13 lbs.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
1. INPUT JACK
Connect instrument cable here.
2. VOLUME
Controls the total output level of amplifier.
3. PRESENCE
Enhances higher frequencies, dampens lower
frequencies.
4. LED
Indicates power on/off.
5. TREBLE
Adjusts high frequency output.
6. MIDDLE
Adjusts middle frequency output.
7. BASS
Adjusts low frequency output.
8. POWER INPUT / FUSE COMPARTMENT
Connection for detachable UL-approved
power cable. Use only the power cable sup-
plied with this amplifier. Fuse compartment
contains a replacement fuse to protect your
amp from power surges, see instructions for
Replacing the Fuse.
9. POWER
On/off switch.
10. AUDIO IN
Input jack for external audio device such as
CD, MP3, or cassette player (device should
have its own volume control).
11. PHONES
Connect stereo headphones here (speaker
output is canceled when headphones are con-
nected).
Open the fuse compartment.
Remove the blown fuse from the inner (active)
slot. Move the new fuse from the outer slot to
the inner slot.
USING ANOTHER TYPE IS A POTENTIAL FIRE HAZARD.
CAUTION
REPLACE ONLY WITH SAME
TYPE 250V, 1A FUSE
.
1 4 3 2 5 6 7
FACEPLATE
BACKPLATE
10 11 9 8
ACTIVE FUSE
REPLACEMENT FUSE