Fujitsu Siemens Computers Docking Station PenCentra 200 - Manual (Page 2)

PenCentra 130 and PenCentra 200 are trademarks of Fujitsu PC Corporation. © 2000 Fujitsu PC Corporation
6/00 58-0677-00B
5. Install the PenCentra 130 or PenCentra 200 in the
docking station.
To do so, press down and hold the latch button on
the right side of the docking station (see Figure 2).
Figure 2. Installing the PenCentra 130 or 200
Tilt the pen tablet to the left and slip the pivot hole
over the pivot point on the left inside of the
docking station (reference arrow #1 in Figure 2).
While holding down the latch button (reference
arrow #2 in Figure 2), gently press the right side of
the pen tablet into the docking station until it is
resting on the base (reference arrow #3 in Figure 2).
Release the latch button and lift the pen tablet to
make sure it is latched in properly.
6. Turn on the peripheral devices attached to the
docking station.
7. Resume PenCentra system operation.
If the required driver software for an attached
peripheral device is not installed, the device may
not work or may work incorrectly. Contact your
local help desk or refer to the documentation
provided with your peripheral device and install
the driver software at this time.
You can now use your pen tablet with the peripheral
devices attached to the docking station.
Disconnecting the Docking Station 0
To disconnect the docking station from your pen tablet,
1. Suspend operation of your PenCentra pen tablet.
2. Turn off peripheral devices that are attached to the
docking station.
3. Push the latch button down to unlatch it from the
pen tablet.
4. Pull the pen tablet out of the docking station in a
straight line. Do not rock the components as you
pull them apart.
You can resume system operation of your PenCentra
130 or PenCentra 200 pen tablet.
Pivot
Point
Latch
Button
Latch
Docking
Station
Pivot
Hole
1
3
2