Fantom Vacuum VPW44H - Manual (Page 5)

OPERATING INSTRUCTIONS GETTING TO KNOW YOUR PRESSURE WASHER
CAUTION
Using the Rotary Brush
The rotary brush is used with the trigger
gun. Push the brush onto the trigger
gun nozzle and turn clockwise to lock
as you would for the lance. (Fig. 6) The
brush may be used for washing cars,
boats, windows and other similar items.
The rotary brush operates at open
orifice pressure so that it will not direct
a stream of water. (Fig. 8)
Fig. 8
Rear View 3
8. Trigger Gun
9. Safety Trigger Lock
10. High Pressure
Hose Connector
11. Trigger
12. Adjustable Lance
13. Garden Hose Coupling
14. Soap Dispenser
15. Power Cord Storage
1. Water Output
2. Water Inlet
3. Accessory Storage
4. Handle
5. On/Off Switch
6. Rotary Brush
7. High Pressure Hose
When you wish to stop using the
pressure washer temporarily, make sure
that the safety lock has been engaged to
avoid any accidental operation. (Fig. 5)
Safety
Lock
Fig. 5
Fig. 7
The angle of the water on the fan jet
lance may be adjusted between 0° and
60° by turning the nozzle adjuster
counter-clockwise for a wider angle or
clockwise for a narrower angle. (Fig. 7)
Always make sure that the "On/Off'
switch is in the "Off" position before
changing the angle of the water jet. It is
also recommended that the trigger gun
safety lock be engaged as well. The
adjustable fan jet lance allows you to use
any variety of spray pattern from a full fan
spray to a direct stream spray. When
using the pressure washer to clean wood
decks, siding, vehicles, etc., always start
using the fan spray and begin spraying
from a minimum 36" away to avoid
damaging the surface of the material that
you are cleaning. Always clear the area
that you will be cleaning of people, pets
and objects.
Using the Adjustable Fan Jet lance
Using Detergent with the Pressure
Washer
Fig. 9
WARNING
The soap dispenser may only be used
with the trigger gun.
Add detergent to the bottle and then
attach the detergent applicator bottle to
the high pressure lance, just push it
firmly onto the end of the trigger gun
and turn clockwise to lock in place.
(Fig. 9) To remove the detergent
applicator bottle, lift the tab on the top
of the connector and pull off.
15
Do not use acids, solvents, or any other
flammable material in this product. These
products can cause physical injuries to the
operator and irreversible damage to the
machine.
Illustrations may differ somewhat from actual product.
Technical Specifications
Voltage: 120V., 60Hz.
Power: 12 Amps
Pressure: 1600 psi. (max)
Flow Rate: 1.65 gpm
7 4