Freecom Technologies Network Drive XS - Manual (Page 7)

7
EN
1
Hardware Installation
Chapter 1: Hardware Installation
WARNING! Only connect the Network Drive XS via the USB or LAN Port.
Never use both ports at the same time!
1. Plug the cable (USB or LAN) into the Freecom Network
Drive XS.
2. Insert the power cord into the Freecom Network Drive XS
and plug the power supply into the socket.
3. Plug the cable into the port (USB or LAN) on your
computer.
Because USB 2.0 is backwards compatible with USB 1.1, you can connect the Freecom
Network Drive XS to any USB port. Please note however that USB 2.0 ports support
significantly higher data transfer speeds than USB 1.1.
Driver Installation: Your computer will not require a special Freecom
driver if you are using Windows XP / Vista / 7 or MacOS X. The required
driver is automatically installed by the operating system when the cable
is plugged into your computer.