Freescale Semiconductor MOTOROLA 94001480400/D - Manual (Page 7)

ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005
ARCHIVED BY FREESCALE SEMICONDUCT
OR,
INC.
2005
MOTOROLA User Interface 2-1
Preliminary
Chapter 2
User Interface
2.1 Buttons
The headset is equipped with a user interface including three buttons, referred to as VOL+, VOL-, and BT
(Bluetooth). On the silk print of the Development Kit PCB, these buttons are designated +, -, and FUNC1
respectively. FUNC2 is never used.
The BT button is mainly used for connection management, including connection transfer 1 , as well as
muting the headset microphone. When an audio connection is present, the VOL+ and VOL- buttons are
used for adjusting the headset speaker volume. In Config. mode, these buttons adjust the indication
volume. When no connection exists, the BT button is used for initiating an outgoing connection to one of
the paired AGs. Either of the VOL+ and VOL- buttons initiates a connection to the other paired AG.
Pressing one of the buttons when powering up the headset enters Config. mode. In this mode, the headset
will require authentication. When successfully paired, the BD address and link key will be stored in one of
two available AG slots. The AG slot to update is selected by the button pressed at power-up: Pressing the
BT button selects slot #1, whereas pressing one of the VOL+ and VOL- buttons selects slot #2. A
successful pairing automatically exits Config. mode, or it may be done manually by pressing the BT
button.
Table 2-1 provides an overview of the way the button actions depend on the system mode.
1. Connection transfer is used to request the audio output endpoint to be moved from the phone/handset to the headset. In terms of Bluetooth
connectivity, this involves requesting a Bluetooth link (ACL&SCO) between phone and headset.
Table 2-1. Button Overview
System Mode BT button VOL +/- button
Idle (not paired) No function
Idle (paired) Attempt outgoing connection to AG#1 if paired
to this. Otherwise attempt #2 Attempt outgoing connection to AG#2
if paired to this. Otherwise attempt #1
Connecting Outgoing Abandon connection attempt
Linked Send AT+CKPD=200 to AG to request link
disconnection No function
Online Brief press: Toggle mic. muting
Held down: Send AT+CKPD=200 to AG to
request link disconnection In-/decrease volume by 3 dB
(repetitive, total of 16 settings)
Config Brief press: Exit Pairable mode (entering Idle
mode), while storing indications volume setting
Held down: Reset all settings to factory default In-/decrease indication volume by 6
dB (total of five settings)
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..