Fisher & Paykel Smart Drive GWLO8 - Manual (Page 27)

RINSE OPTIONS
On the Heavy Duty, Regular and Wool cycles you
can change the pre-set rinse option.
The pre-set rinse option on these cycles is a spray
rinse followed by a deep rinse. The spray rinse may
be replaced with a short spin or a deep rinse.
If you have a problem with impurities in your water
supply you may get a better wash if you change the
rinse option to two deep rinses. If you want to
conserve water change the rinse option to one deep
rinse.
1. Enter the Option Adjustment Mode as explained
on pages 23 and 24.
2. Use the SPIN SPEED buttons to select the rinse
option you prefer.
MED light on
= 2 deep rinses
SLOW light on = Short spin and
1 deep rinse
HOLD light on = Spray rinse and
1 deep rinse
3. Press POWER to return to normal mode.
VOLUME OF WATER USED IN THE
WATER SAVER OPTION
You can increase or decrease the volume of water
added during the shower rinse on the Water Saver
option.
1. Enter the Option Adjustment Mode as explained
on pages 23 and 24.
2. Use the WATER LEVEL buttons to select the
volume of water you wish to be used in the
shower rinse.
HIGH light on = more water
MED light on
= factory set water volume
LOW light on = less water
3. Press POWER to return to normal mode.
RINSE OPTIONS
MED spin Deep Deep
light on rinse rinse
SLOW spin Short Deep
light on spin rinse
HOLD Spray Deep
light on rinse rinse
25
1133 LDY Use & Care (USA) 16/5/01 3:34 PM Page 27