Flymo 511967501 - Manual (Page 7)

Maintenance
S
R
• WARNING
Disconnect from the mains electricity supply,
before attempting any maintenance or adjust-
ment. Cutting head continues to rotate after the
trimmer has been switched off. Keep fingers and
hands clear of the line cutter on leading edge of
guard.
Caring for your Power Trim
After you have finished using your Flymo Power Trim fol-
low the procedure below:
AVOID ACCIDENTAL STARTING. REMOVE PLUG
FROM MAINS AND KEEP FEET AWAY FROM THE
SWITCH LEVER WHEN: CLEANING AROUND THE
INSIDE OF THE SAFETY GUARD, REMOVING OR
REFITTING SPOOL CAP, MANUALLY FEEDING OR
REPLACING NYLON LINE.
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water, cleaning fluids,
or solvents, just remove debris with a suitable tool, a
soft brush or dry cloth.
3. Using a soft brush, clean around the inside of the
safety guard, the cutting head (Fig R) and the motor
housing air vents. (Fig S)
4. Inspect the trimmer carefully, especially the parts of
the cutting head.
5. If your trimmer is damaged in any way contact your
local Electrolux Outdoor Products approved service
centre.
• Never use a damaged trimmer.
6. Store in a cool, dry place and out of reach of chil-
dren.
Cable Storage
1. Your mains cable can be stored on the product as
illustrated in Fig T.
2. Wind cable carefully to avoid kinking.
3. To release the cable press the button and the hook
will drop down (Fig V).
4. Push cable hook fully back into position.
V T