FUNAI V07LCD15 - Manual (Page 14)

14
EN
W
ATCHING TV
Switching Each Mode
You can easily switch with the remote control to the DTV (ATSC) and TV
(NTSC) or to access an external device when they are connected to the unit.
Press [INPUT] repeatedly to cycle through the input
mode.
ANALOG MODE
DIGITAL MODE
VIDEO1
VIDEO2
• To use the video or S-video input jack on the unit,
select “VIDEO1”.
• To use the component video input jack on the unit,
select “VIDEO2”.
Note:
• When you switch the analog mode to the digital mode,
it may take a while until the digital channel selection is
completed. The following TV screen is displayed while
switching the mode.
NOW SCANNING
5 Switching Audio Mode
This section describes how to switch the audio in the analog mode and how
to switch the audio language in the digital mode.
TV
While receiving an MTS broadcast, press [AUDIO ]
repeatedly to cycle through the available audio channel.
MAIN
SAP
MONO
MAIN : Outputs main-audio
SAP : Outputs second audio program
MONO : Outputs mono-audio
• The current mode will automatically disappear in a
few seconds.
DTV
1
Press [AUDIO ] to display the currently selected
language and the number of available languages.
KABC CH 95-03
A Day of Memories
ENGLISH 1/3
2
Press [AUDIO ] repeatedly to cycle through the
available audio languages.
• Available languages differ depending on the
broadcast. “OTHER” is displayed when the audio
language cannot be acquired, or the acquired
languages are other than English, Spanish or French.
• The current mode will automatically disappear in a
few seconds.
Note:
• Pressing [AUDIO ] does not control external audio device.
5